• Extend your holder from your car mount or any flat surface
• This Block Spacer will extend your device holder 25 mm (1 inch) from the car mount.
• Screws for attaching the Block Spacer to the car mount are enclosed.

This high quality mount is designed to fit phones with OtterBox uniVERSE cases. Simply snap your phone into place on the rail mount for a secure fit.

• Fits any OtterBox uniVERSE phone case
• Includes Tilt-Swivel to angle holder 15 degrees any direction
• Rotate between portrait and landscape view

• Attaches to 75mm existing VESA systems
• Made in Sweden from Durable Machined Aluminum
• 4 - Pre-drilled and 4mm threaded AMPS pattern holes to easily attach ProClip products

• Attaches to 75mm and 100mm existing VESA systems
• Pre-drilled 4mm threaded AMPS pattern holes to easily attach ProClip products

• Adds an additional 15 degrees of angle to your mounting surface
• Can be attached between a mount and a holder
• Heavy Duty Aluminum design for heavy devices
• Includes M4 thread AMPS pattern in vertical and horizontal position
• M4 through holes allow mounting to pedestals, wall mounts, and more.

• Designed for the Crown Work Assist Pipe Clamp
• Converts the clamp to an AMPS Interface
• Recessed holes enable flush mounting.

• Attaches to any existing VESA 75mm or 100mm mounting system
• Use to create a new recessed mounting surface to allow the attachment of ProClip specific holders
• 4 pre-drilled AMPS pattern pilot holes to attach ProClip holders more securely
• 5 mm Diameter Holes accommodate up to M5 screws

• Reduce vibration in your mounted device
• Steel Plates set in Heat Formed Rubber
• Supports AMPS 4 Hole Pattern
• Threaded M4 Holes for Installation
• For Devices Not Wider or Taller than 6"
• Not Designed for Tablets or Larger Devices

• Reduce vibration in your mounted device
• Supports AMPS and VESA75 Hole Pattern
• Steel Plates set in Heat Formed Rubber
• Threaded M4 Holes for Installation
• Designed for Vibrations above 100 Hz (100 Times a Second)
• Maximum supported weight: 15 Lbs. (6.8 Kg)

• Extension plate allows an additional device holder to be added
• Multiple Locations for AMPS hole pattern mounts
• Made from durable steel
• 7.28 in (18.5 cm) x 2.36 in (6 cm) x .12 in (3 mm)

• Extension plate allows an additional device holder to be added
• Multiple Locations for AMPS hole pattern mounts
• Made from durable steel
• 11.8 in (30 cm) x 2.36 in (6 cm) x .12 in (3 mm)

• Provides a strong mounting platform
• Strong Metal Construction

Keep your device conveniently within reach with the Magnetic Adapter for OtterBox uniVERSE from ProClip USA. Quickly dock or undock your tablet with a sturdy magnetic mount.

Standard website promos do not apply to this item.